Tool review (Banggood 10mm lathe tool set)

click to begin

Youtube

I've just had this parcel arrived from Banggood it's a set of turning tools for
the lathe seven tools 10 millimeter shank and a set of carbide tips.
so what I'll do is I'll take them out of the box, lay them out fit the tips and then we'll
go through each tool see what we get in the kit

here are the tools that you get in the kit I'll just run through them.
the first three tools I've used and I'll put some of the clips of the video in
they're all ten millimeter by ten millimeter shanks all these tools come
with one insert but most of them have got two cutting edges and the thread
turning tools have three cutting edges.
This is SDJ CR1010HO7
the others that come with it are SCLCCR1010HO6
and this one is a SDNCN1010H07
the tip in this one and this one is the same tip same shape and the tip in this
one and the boring bar which is here is the same tip this one is in a S10K-SCLCR06
the thing I like about this one is the measurements down the side so you
can see how deep you go into the bore on this boring bar it's got up to 50mm in depth
marked on the side of the tool.
This is the thread cutting tool SNR0010K11 for internal threads
this one's the thread cutting tool for
external which is SER1010H11 and then the last one you get is a parting off
tool which is MGEHR1010-2
the only thing that's I haven't tried is the screw cutting tips which I will try
in a future video they all come with allen key or tourx keys having used the
tips I found that the tooling is a very comprehensive set for the smaller lathe
or even for the larger lathe making smaller components the only thing I
could say was that you must remember that the tips have got a radius on so if
you're looking for a sharp corner you'll have to go over the corner again with a
sharper tip and when you consider that the whole set is under £30
I think that's very good value for money
I hope that was useful and we'll see you next
time on Enots engineering
Finish and test first drill grind. Milling a dovetail block in the Lathe. Indexing ring and feed screw Offset tool tip holder for radius cutter DTI holder from scrap Grinding wheel dresser Spindle block and locking screw Spindle with ER20 collet holder. Headstock Bearing adjustment and back gear. Motif for a model steam engine

Tool review (Banggood 10mm lathe tool set)

Latest Posts