Bread Crumb Board (Woodworking How To)

click to begin

Youtube

Thickest pieces "resawn" for less work at thicknesser
Square one end, flip and put that end against flip stop
Ripping crappy side off jarrah "breadboards"
resaw jarrah to save thicknessing time
same as before - square, flip, cut to length
layout lines for drilling mortises
each 'set' is spaced 15mm + 5mm apart
Marking drilling holes with awl makes it easier to line up at the drill press
I did chisel out half of them, but it was taking too long. Don't be afraid to cheat.
square peg, round hole. Square the mortise or round the tenon
24 mortises and tenons require a little bit of persuasion
Do you want to see an episode on guide bushings?
"Damper is a traditional Australian soda bread, historically prepared by swagmen, drovers, stockmen and other travellers"
Turbo Plane vs Ball Gouge Bosch PBD40 Drill Press Review WTF is Jarrah? How to build a (hatchet inspired) woodworking mallet Bookmatched Blackwood Resin River Coffee Table | Sounds of the workshop Dice Tray WTF is Tasmanian Oak? Wooden Allen Key (& Wood Socket Head Cap Screw) Sounds of the Workshop: Outdoor Kitchen Simple Finishing Supplies Cabinet

Bread Crumb Board (Woodworking How To)

Latest Posts