
we'll show you how to use your circulation promoter
with the accessory pads.
To begin, remove the pain therapy control unit
from the base, turn it over
and install two triple A alkaline batteries.
Please note that these are not included with the system.
Open the bag that contains the foot relief pads.
The instruction manual is included inside the bag.
These are not insoles
and should never be placed inside shoes.
Plug the yellow lead wire from the foot relief pads
into the top of the pain therapy control unit.
Slowly turn the intensity dial clockwise
until it clicks on, then very slowly continue
to turn up the dial to increase intensity
to the desired comfort level.
Press the mode button to change the type
of stimulation, press the time button
to select 10, 20, or 40 minutes of treatment time.
The water spray bottle can be filled with tap water.
No special water is needed.
Place the two foot relief pads onto the floor.
Be sure they are not touching each other.
For best results, place on a hard surface
and do not use on carpet.
Spray the foot relief pads with water
and spray the bottom of bare feet prior
to placing feet on the pads.
Place both feet on the foot relief pads.
To use the system with accessory gel pads,
open the bag that contains the instruction manual,
instructional DVD,
and pad placement chart inside.
Depending on your desired treatment area,
consult the chart for which type of pad to use
and where to best place the pads for optimal relief.
Locate the gel pad wires and open the package.
Plug the yellow end into the top
of the pain therapy control unit.
If your control unit is attached to the base plate,
you'll need to disconnect the base plate wire first.
You can see that the gel pad wires have two plugs
for either the small or large gel pads.
For the small pads, remove them from the packaging
and attach the wire leads
from the control unit to the gel pads.
Remove the clear protective film from the pads.
Keep and reapply when done.
Slowly turn the intensity dial clockwise
until it clicks on, then very slowly,
continue to turn up the dial to increase intensity
to the desired comfort level.
As with the foot pads, you can press mode or time
to change the modality or length of treatment.
Treatment is the same if using the large FlexTone pads.
Remove them from the packaging and attach the wire leads
from the control unit to the gel pads.
Again, if your control unit is attached
to the base plate or to the small pads,
you will need to disconnect the wires first.
Spray pads with water and place on the area to be treated.
You must have two electrodes on the same muscle
to feel any stimulation.
Put Silver Foil In Washing Machine And You'll Be Amazed With What Happens Next 27 Travel PACKING HACKS - How to Pack Better! Put Baking Soda On Your Garden Plants and This will Happen 10 Best Insoles 2017 38 Ideas with Plastic Bottles Yoga for Neck and Shoulder Relief - Yoga With Adriene 18 Min Sciatica Exercises for Leg Pain Relief - Sciatica Relief & Treatment for Sciatic Nerve Pain How to: Measure Blood Pressure AMAZING Way To SUPER CLEAN The NASTIEST Carpet ! Relaxing Music for Meditation. Soothing Background Music for Stress Relief, Yoga, Massage, Sleep